This page describes Revolution release 3.1.0.
Search these docs, or ask Revo a question — answers link the pages they came from.
Schedule parameters in Python
When Python runs as a step in a schedule
(Run Python or
Run Python Script), it
can read and write that schedule’s parameters through revo.parameters:
import revo
count = revo.parameters["PlateCount"] # read by namerevo.parameters["PlateCount"] = count + 1 # write by namedone = revo.parameters.AllPlatesDone # or use the name as an attributerevo.parametersreads and writes the parameters declared on the schedule, so declare a parameter there before a Python step uses it (see Schedule parameters).- The value written must suit the parameter’s type.
- Reads and writes apply to the thread the step runs on.
revo.parametersis available to Python running as a schedule step.
A common use is a decision that needs more than an expression: a Python step works out the answer and writes it to a Boolean parameter, and an If..Else step then branches on that parameter.
Pass a value between blocks
Section titled “Pass a value between blocks”A value one block writes is visible to the blocks after it on the same schedule thread, and a later
schedule step reads it as ${name}. Here the schedule declares a whole-number parameter named
plates sealed, with Input off because the scripts set it. An earlier block seeds the count:
import revo
revo.parameters.plates_sealed = 0 # by its Python nameprint(revo.parameters["plates sealed"]) # or by its real name: the same parameterA later block on the same thread reads it back and branches:
import revo
sealed = int(revo.parameters.plates_sealed or 0)if sealed == 0: print("Nothing sealed yet on this schedule thread.")revo.parameters.plates_sealed = sealed + 1